Problem solving guide
105
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
This section only lists faults that you can remedy yourself. All other faults are
shown in Fault FXX.
Technical problems
Problem Possible cause and remedy
The display remains
dark after the
dishwasher has been
switched on with the
sensor.
The dishwasher is not plugged in or the socket is not
switched on.
Insert the plug and switch on at the socket.
The circuit breaker has tripped.
Reset the circuit breaker in the mains fuse box
(see data plate for minimum fuse rating).
If the circuit breaker trips again, call Miele.
The dishwasher stops
during a programme.
The circuit breaker has tripped.
Reset the circuit breaker in the mains fuse box
(see data plate for minimum fuse rating).
If the circuit breaker trips again, call Miele.
To Next Page
Loading...
Need help?
General
