Catalytic enamel surfaces
The removable back panel, side liners
(if fitted) and roof liner are coated with a
dark grey catalytic enamel.
During fan operated cooking circulating
air in the oven deposits oil and fat
splashes predominantly on the back
panel of the oven. These splashes are
burnt off when the temperature of the
oven reaches over 200°C during baking
or roasting. The higher the temperature
the more effective the process.
The oven and accessories should be
cleaned after each use. Otherwise
further baking and roasting will cause
the deposits to bake on even harder
and cleaning may become difficult and
in extreme cases impossible.
Cleaning by hand
Allow the oven to cool down before
cleaning. Danger of burning!
^
Catalytic enamelled panels should be
cleaned using a solution of hot water
with a little washing up liquid applied
with a soft nylon brush.
Do not use abrasive cleaning
agents, hard brushes, scouring
pads or cloths, steel wool, knives or
other abrasive materials and do not
use oven spray on catalytic enamel
as the chemicals used in oven
sprays will damage catalytic enamel
rendering it ineffective.
If using oven sprays on PerfectClean
oven surfaces the catalytic back
panel, side liners (if fitted) and roof
liner must first be removed from the
oven.
Cleaning and care
60
To Next Page
Loading...
Need help?
General
