Programme options
62
Optimise standby
"Optimise standby" is activated by
default.
To save energy, the dishwasher will
switch off automatically a few minutes
after the last time a button has been
pressed or after the end of a
programme.
The dishwasher will not switch off
whilst a programme is running, during
the Delay start period or if there is a
fault.
"Optimise standby" can be switched off
if you prefer. If you do this, the duration
before the dishwasher switches off
increases to 6hours. Doing this will
increase energy consumption.
Switch the dishwasher off with the
button, if it is switched on.
Press the /button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the /button pressed in for
at least four seconds until the /
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button eight times.
The indicator light will flash rapidly
eight times at intervals.
The flashing sequence in the display
shows whether Optimise standby is
activated or not.
– : "Optimise standby" is switched
on.
– : "Optimise standby" is switched
off.
Press the / button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
