Warning and Safety instructions
6
Please read these operating instructions supplied with the ironer before using it for the
first time. They contain important information on the safety, use, and maintenance of the
ironer.
This prevents both personal injury and damage to the appliance.
If other persons are being shown how to operate the ironer, they must be given or made
aware of these important safety instructions.
Keep these operating instructions in a safe place and pass them on to any future owner.
Appropriate use
This ironer must be used as described in these instructions and must be checked on a reg-
ular basis to make sure it is functioning correctly.
This ironer is only intended for ironing fabrics that were washed in water. Check fabric
care labels to verify that the articles are suitable for machine ironing.
This ironer is intended for use in commercial settings. It is not intended for domestic
use. If the ironer is operated in a publicly accessible place, it is the supervisor's responsib-
ility to ensure suitable measures are in place to protect users from any source of risk or
danger.
This ironer is not intended for outdoor use.
Technical and electrical safety
This ironer should not be operated in the same room as dry-cleaning equipment using
perchloroethylene or solvents containing CFCs.
This ironer should only be operated in a suitable dry room.
Only operate this ironer when all removable outer panels are in place so that it is im-
possible to touch an electrical component or moving part.
Do not damage, remove or bypass the safety components or control elements of this
ironer.
Do not make any alterations to the ironer unless authorised to do so by Miele.
If the controls or the electrical cabling insulation has been damaged, this ironer must not
be used until it has been repaired.
Repairs and other work by unqualified persons could be dangerous. The manufacturer
cannot be held liable for unauthorised work. Repairs may only be carried out by a Miele
authorised service technician.
Faulty components must only be replaced by genuine Miele Original spare parts. The
manufacturer can only guarantee that the machine fully complies with safety requirements
when Miele replacement parts are used.
The electrical safety of this ironer can only be guaranteed if connected to a correctly in-
stalled earthing system on site. It is most important that this standard safety requirement is
present and tested regularly, and where there is any doubt the on-site electrical system
should be tested by a qualified electrician. Miele cannot be held liable for damage or injury
caused by the lack of or inadequacy of an effective earthing system.
To Next Page
Loading...
Need help?
General
