Control panel PT 8301 Profitronic B Timed programmes
12
3456 7 8
1 Segment display - Time 2 Programme sequence display 3 Temperature selection button
4 Venting system fault indicator 5 Fluff filter fault indicator 6 START/STOP button
7 Time selection rotary dial 8 On/Off switch
Mains On/Off switch s
Switches the machine on or off.
Temperature selection button
For setting the required drying temperature - Cold,
Low, Medium, High. The corresponding LED will
light up.
Time selection rotary dial u
Programme durations of up to 60 minutes can be
selected in five minute stages from 5 to 60 minutes to
suit different fabric types and depending on how the
laundry is to be further processed. The
corresponding LED will light up. The drying duration
can also be altered during the drying process.
START/STOP button
Press the Start/Stop button to start or stop the drying
programme.
Segment display
Before the start of a programme, this shows the
selected drying duration in minutes.
After the start of a programme, it shows the time left
to the end of the programme.
It also shows fault messages, see "Problem solving
guide".
It can also show h for "Peak load cut-out" (optional).
Programme sequence display
The programme sequence is displayed in three
stages. The stage the programme is at will be
highlighted in yellow.
! Drying
L Cooling down
O Programme finished / Anti-crease
Check venting system 0 fault indicator
This will light up if there is a problem with the venting
system.
Clean the fluff filter W fault indicator
This will light up when the fluff filter needs to be
cleaned.
Description of tumble dryer PT 8301
10
To Next Page
Loading...
Need help?
General
