Error messages
Indicator Possible cause Remedy
N 0
Over-pressure in vent ducting.
Leaks in the airways.
Check the vent ducting.
Call the Miele Professional Service
Department.
N W
Fluff filter blocked Clean the fluff filter.
The dryer does not start. The fluff filter compartment flap is not
closed properly.
Twist the lock for the fluff filter compartment
flap in a clockwise direction as far as it will
go.
Gas burner malfunction Press the START/STOP button.
Other messages
Peak load cut-out
The dryer will continue to run without
heating (cold) for the remainder of the
programme.
If the peak load cut-out is overridden, the
programme will continue as normal.
In the event of any of the following faults, please contact the Miele Professional Service Department:
– excessive noise
– there is a gaseous or burning odour
– the tumble dryer does not start after cleaning, or after several attempts at starting it
– the drying time is excessively long
– the laundry does not dry
– the fluff filter is damaged
–
the door seal is damaged
–
the door lock is damaged
–
any accessories are damaged
When contacting the Professional Service Department, please quote the Model, Serial number (SN:) and Material
number (M.Nr) of your dryer.
See data plate for details:
The data plate is located at the top of the door aperture with the door open or at the top of the rear of the
machine.
Problem solving guide
20
To Next Page
Loading...
Need help?
General
