Control panel PT 8301 Profitronic B COP (Coin Operation)
12
3456 7
1 Segment display - Time 2 Programme sequence display 3 Temperature selection button
4 Venting system fault indicator 5 Fluff filter fault indicator 6 START/STOP button 7 On/Off switch
Time selection can be controlled by a C 4065 or C 4070 coin control unit or other type of payment system.
^ Press the mains On/Off switch s
^ Load the drum and close the door.
Select a temperature
^
Press the temperature selection button and select
the required drying temperature - Cold, Low,
Medium, High.
The corresponding LED will light up.
Cold For airing textiles
Low Delicates, synthetic fibre and rayon fabric
Medium Minimum iron, synthetic and mixed fibre
fabric
High Cottons, cotton and linen fabric
^
Insert coins or tokens.
The START/STOP button will start flashing.
^
Press the START/STOP button.
At the end of the drying duration
! Drying
L Cooling down
O Programme finished / Anti-crease
At the end of the drying duration the "Drying" and
"Programme finished" programme sequence stage
symbols will flash. "Cooling down" will light up and the
cooling down phase will begin.
^
Remove the laundry (the laundry will still be hot).
! Drying
L Cooling down
O Programme finished / Anti-crease
At the end of the cooling down phase all three
programme stage symbols will flash and the buzzer
will sound.
^
Remove the laundry.
Interrupt the programme by opening the drum door
or the fluff filter compartment flap:
^
Continue the programme by closing the drum
door/fluff filter compartment flap and pressing the
START/STOP button.
Short operating instructions which can be used as
a wall chart are supplied with the dryer.
PT 8301 COP
17
High
Medium
Low
Cold
To Next Page
Loading...
Need help?
General
