Installation and connection
40
Levelling the dryer
The appliance must stand perfectly
level on all four feet to ensure safe and
proper operation.
The screw feet can be adjusted to
compensate for any unevenness in the
floor.
Do not block the gap between
the bottom of the tumble dryer and
the floor with plinth facings, deep
pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
of the pump. This water can run out if
the tumble dryer is tipped up when it is
being moved. It is a good idea to run
the Warm air programme for
approximately 1 minute before moving
the tumble dryer. Any remaining
condensed water will then be fed into
the condensed water container or out
through the drain hose.
Washer-dryer stack
The tumble dryer can be combined with
a Miele washing machine in a washer-
dryer stack. The appropriate "WTV"
stacking kit* to match your dryer is
required.
* Miele accessory available to order
Stacking kits must only be
installed by a suitably qualified fitter.
To Next Page
Loading...
Need help?
General