Cleaning and care
63
Cleaning the plinth filter access panel
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
Close the heat exchanger access
panel.
Damage or ineffective drying if
drying takes place without a plinth
filter or when the heat exchanger ac-
cess panel is open.
An excessive accumulation of fluff
can damage the tumble dryer. If the
system is not leak-tight, this can
make drying ineffective.
Only operate the tumble dryer with
the plinth filter fitted and the heat ex-
changer access panel closed.
Cleaning the dryer
Disconnect the tumble dryer from the
electrical supply.
Damage due to the use of un-
suitable care products.
Unsuitable care products could dam-
age plastic surfaces and other parts.
Do not use any solvents, abrasive
cleaners, glass cleaners, or all-pur-
pose cleaners.
Clean the tumble dryer and the seal
on the inside of the door with a
slightly damp soft cloth and a mild
solution of washing-up liquid and wa-
ter.
Dry all parts with a soft cloth.
To Next Page
Loading...
Need help?
General
