I Add detergent
It is important to dispense the correct
amount, because . . .
. . . too little results in the following:
–
Laundry will not be properly clean
and will in time become grey and
hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater
elements.
. . . too much results in the following:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an
additional rinse cycle will
automatically switch in).
– A burden to the environment.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i
Detergent for Pre-wash (if selecting
Pre-wash, add
1
/
4
of the total amount
recommended)
j
Detergent for the main wash
including Soak
§
Fabric conditioner or liquid starch.
See section on “Detergent” for further
information on detergent and the
amount to dispense.
J Press the Start button.
This starts the programme.
How to wash correctly
22
To Next Page
Loading...
Need help?
General
