EasyManuals Logo
Home>Mikado>Remote Control>VBar Control

Mikado VBar Control User Manual

Mikado VBar Control
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
Built-in rechargeable Lithium Polymer Battery and Battery charger
Take special care with the following to prevent unwanted heat generation, re and explo-
sion.
Danger Use only the supplied wall charger with the appropriate adapter. Check the voltage in the
country you are in, it must not exceed 100-240 V AC.
» Do not misconnect (+) and (–)
» Do not place VBar Control or the charger next to heat or open re.
» Keep open terminals (+) and (–) away from conductive materials like metal surfaces, carbon -
bre, tools.
» Never disassemble or modify VBar Control beyond what is described in this manual, and never
solder.
Danger Never use other than genuine batteries from Mikado Model Helicopters. The batteries
have been carefully selected and adapted for use in VBar Control. Always monitor the charging
process, even if the integrated charging circuit takes care of the proper charging parameters. Stop
the charging process immediately if you experience excess heat.
» Never wet the battery with any water.
» Never harm the insulation, connecting wires, connectors.
» Do no longer use a battery that has taken damage to the insulation, connecting wires, connec-
tors.
» Battery liquids are dangerous. If your eyes, skin or clothes get in contact with these, rinse thor-
oughly and wash your clothes with clean water.
» Always monitor the condition of your batteries by checking the operating time, charging time. If
operating times or charging times start to differ strongly, the end of their lifetime may have come.
» Battery failure may cause your model going out of control, causing dangerous situations.
Attention Never store your VBar Control and the battery inside in high temperature, very dusty or
very humid conditions.
» Store the VBar Control and the battery inside outside of the reach of infants.
» Never charge the battery of your VBar Control in very cold conditions (lower than 0 °C).
» A used Lithium Polymer battery is not domestic waste. Discharge the battery, insulate the termi-
nals with tape or the like, and bring it to a store/dealer that disposes of small rechargeable bat-
teries, or bring it to a collection point for harmful substances.
» Never keep the VBar Control in direct sunlight for extended time. Keep it in the shadow if it is not
used.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mikado VBar Control and is the answer not in the manual?

Mikado VBar Control Specifications

General IconGeneral
BrandMikado
ModelVBar Control
CategoryRemote Control
LanguageEnglish

Related product manuals