25
Battery charging
■ The built-in battery will be charged every time it is connected to a personal computer,
using the USB cable. A green light will come on in the EDS Dial when the VBar Control
is connected to a live USB port.
■ To charge VBar Control away from a personal computer, connect the wall charger pro-
vided to a wall outlet. Select the appropriate adapter for your country. A red light will
come on in the EDS Dial when the VBar Control is connected to the wall charger.
■ Connect the charger to VBar Control.
■ Charging time from the wall charger will be approx. 1.5 hrs.
■ When left on the wall charger, trickle charge will keep the battery fully charged.
■ Charging time from the USB cable will be approx. 10 hrs (with the transmitter turned ON)
or 40 hrs (with the transmitter turned OFF). This is due to technical regulations of the
USB power supply.
■ You can positively connect both the USB cable and the wall charger. The integrated
charging circuit in your VBar Control transmitter will always use the input with the highest
power and disable the other input.
■ In case the battery is exhaustively discharged, the charging time will noticeably increase
to safely get the battery back to life.
Tips for using your VBar Control transmitter
■ Power saving
Set the low threshold of the ambient light sensor to a low value, so the transmitter can
always use the least power needed for the display.
■ Range Check
((how to?))
■ Recovery
((how to?))
To Next Page
Loading...
Need help?
General
