MikroTik AP User Manual

NC/AP Staging Instructions:
1. Plug the NC power cord into the PoE injector as shown below and connect the power
cord to a functioning power outlet. Plug an ethernet cable to the other end of the PoE
injector, a light on the injector indicates successful connection to power.
2. Perform a Factory Reset on the NC: Hold down the NC reset button (circled below) and
THEN insert the other end of the ethernet cord connected to the PoE injector into Port 1
of the NC as shown below. The reset button must be held down BEFORE connecting the
ethernet cable.
Continue holding the reset button until LED light starts flashing (takes 5 seconds) then
immediately release the button to reset RouterOS configuration.
NOTE: If the reset button is held down too long the LED will turn solid. If this happens,
unplug the ethernet cable and perform another factory reset.

MikroTik AP Specifications

General

Brand	MikroTik
Model	AP
Category	Network Hardware
Language	English