1.
2.
3.
Powering
The device has dual removable (hot-swap compatible) power supply units AC 110-240V with standard IEC compatible sockets. Maximum power
consumption of 73 W.
Reset button
The reset button has two functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration.
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Mounting
The device is designed to use indoors and it can be mounted in a rackmount enclosure using provided rack mounts, or it can be placed on the desktop.
Use a Phillips screwdriver to attach rackmount ears on both sides of the device if designated use is for rackmount enclosure:
Attach rack ears to both sides of the device and tighten four screws to secure them in place, as shown on the picture to the right;
Place the device in rackmount enclosure and align with the holes so that the device fits conveniently;
Tighten screws to secure it in place.
The device has no protection from water contamination, please ensure the placement of the device in a dry and ventilated environment. We recommend
Cat6 cables for our devices.
LEDs
The device has four LED lights. PWR1/2 indicates which power supply is being used. FAULT indicates a problem with the cooling fans. USER can be
configured in software.
Operating System Support
The device supports RouterOS software with the version number v6.46 at or above what is indicated in the RouterOS menu /system resource. Other
operating systems have not been tested.
To Next Page
Loading...
Need help?
General