CSS326-24G-2S+
The CSS326 is a network switch with 24 gigabit ethernet ports and two SFP+ cages (modules
are not included). The device is ready to use as a switch. To access its full functionality, you
need to connect to the SwOS web interface.
Powering
The board accepts powering in the following ways:
• direct-input power jack (5.5mm outside and 2mm inside, female, pin positive plug) accepts
10-30V DC
• The ethernet port accepts passive Power over Ethernet 8-30V DC, PoE injector is not
included!
"
The power consumption of this device under maximum load is up to 19W
Configuration
The CSS is set up as a switch, with 192.168.88.1 as the management IP accessible from any
port. You can connect to the SwOS configuration interface by opening http://192.168.88.1 and
using admin as the login name. There is no password by default.
Reset button
Hold this button during boot time and release after LED light stops flashing to reset SwOS
configuration and load primary backup firmware.
Access to primary firmware allows reinstallation of the main firmware.
Operating System Support
The CSS runs SwOS, which is the only supported OS for this device. Information about SwOS: "
http://wiki.mikrotik.com/wiki/SwOS
CSS326 SwOS features
• Non-blocking Layer 2 Switching Capacity
• 16K Host table
• IEEE 802.1Q VLAN
• Supports up to 4K simultaneous VLANs
• Port isolation
• Broadcast Storm Control
• Port Mirroring of ingress/egress traffic
• MikroTik neighor discovery
• SNMP v1
• Web-based GUI
To Next Page
Need help?
General