MikroTik DynaDish 5 User Manual

4.
5.
Align as needed and secure screws in step 3.
Note, the position of the ethernet cable must face down.
Please secure all loose Ethernet cables and antenna cables to the pole or mast approximately 30cm from the device, so that the cable weight is
not pulling the ports and connectors.
Buttons and Jumpers
The reset button has the following functions:
Hold this button during boot time until the LED light starts flashing, release the button to reset the RouterOS configuration (total 5 seconds).
Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will now look for a CAPsMAN server (total 10
seconds).
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15
seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Included parts

MikroTik DynaDish 5 Specifications

General

Chipset	QCA9882-BR4A-R
Internal memory	128 MB
Internal	No
Product color	White
AC adapter included	Yes
AC input voltage	11 - 60 V
Power consumption (max)	16 W
Frequency band	5.170-5.250, 5.725-5.835 GHz
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Antenna features	Integrated antenna
Antenna gain level (max)	25 dBi
Ethernet LAN (RJ-45) ports	1
Horizontal beam width	8 °

Weight and Dimensions

Depth	175 mm
Height	404 mm