1.
2.
3.
1.
2.
3.
1.
We recommend clicking the "Check for updates" button in the QuickSet menu, as updating your RouterOS software to the latest version ensures the best
performance and stability. For wireless models, please make sure you have selected the country where the device will be used, to conform with local
regulations.
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: . In case the IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC https://mt.lv/help https://mt.lv/winbox
address.
For recovery purposes, it is possible to boot the device for reinstallation, see section .netPower 15FR#Buttons and Jumpers
Powering
The device accepts power in the following ways:
Ethernet ports accept passive PoE 36-57 V DC .
Direct-input power jack (5.5 mm outside and 2 mm inside, female, pin positive plug) accepts 18-57 V DC.
Use included DC plug to connect with your power source:
DC plug 2.1x5.5x12 mm to Screw Terminal 2pin.
Connect your power source cables to the two pins and secure them in place by tightening screws.
Connect the DC plug to the device.
The power consumption under maximum load can reach 10 W, with attachments 28 W.
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Power output
The device supports passive PoE from one Ethernet marked in amber color. You can power Mikrotik devices which supports powering through Ethernet.
The power delivered through the PoE port will depend on the incoming to the device.
Bottom Lid
The bottom lid is secured in place with the captive screw, it can be unscrewed by hand, but do not remove the screw completely.
To Next Page
Loading...
Need help?
General
