MikroTik netPower 16P User Manual

Mounting points:
There are eight mounting points on the back of this device. Choose the most relevant ones.
Middle points are designed for mounting on the mast, there are curves on the case for slim fitment.
The device must be mounted by UP arrow facing upwards.
Attach your grounding wire to the grounding screw.
Attach the other end of the grounding wire to the grounded mast.
Mounting and configuration of this device should be performed by a qualified person.
Mounting on the mast or pole:
It's recommended to secure Ethernet cable to the pole using zip ties. With the distance from the device approximately 30 cm.
The installation infrastructure (towers and masts), as well as the router itself, must be properly grounded. The device includes a grounding wire
attachment screw on the backside.

MikroTik netPower 16P Specifications

General

Switch type	-
Switch layer	L2/L3
Flash memory	16 MB
Internal memory	256 MB
Processor model	98DX226S
Built-in processor	Yes
Processor frequency	800 MHz
Operating temperature (T-T)	-40 - 70 °C
Power connector	DC-in jack
SFP+ module slots quantity	2
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
DC input voltage	18 - 57 V
Power consumption (max)	316 W
10G support	No
Networking standards	IEEE 802.3af, IEEE 802.3at
Certification	CE/RED, EAC, RoHS
Product color	White
Forwarding rate	53.6 Mpps
MAC address table	- entries

Weight and Dimensions

Depth	78 mm
Width	212 mm
Height	303 mm