Dimensions 222 x 239 x 57 mm
Operating temperature -40°C to +70°C
Buttons and jumpers
The RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when the green LED starts flashing, to reset the RouterOS configuration to defaults.
Release the button after the LED is no longer lit (~20 seconds) to cause a device to look for Netinstall servers (required for reinstalling RouterOS
over the network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
LED
Hidden Green LED behind the Reset button is a USER LED
Blue LED 1 is the DC1 Power LED
Blue LED 2 is the DC2 Power LED
Green SFP+ LED is an SFP+ port link and activity LED
Ethernet RJ45 Green LEDs are Ethernet port link and activity LEDs
Ethernet RJ45 Port 1 Orange LED is PoE-in status LED
Ethernet RJ45 Port 2-8 Orange LEDs are unused on this model
Accessories
The package includes the following accessories that come with the device:
Operating system support
The device supports RouterOS software version 7.8. The specific factory-installed version number is indicated in the RouterOS menu /system resource.
Other operating systems have not been tested.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a commercial installation.
To avoid pollution of the environment, please separate the device from household waste and dispose of it in a safe manner, such as at
designated waste disposal sites. Familiarize yourself with the procedures for the proper transportation of the equipment to the designated
disposal sites in your area.
To Next Page
Loading...
Need help?
General
