Mindray BeneView T5 Quick Guide

1
Product Overview
Front View
1. Handle(T5 only)
2. Alarm lamp
When a physiological alarm or technical alarm occurs, this lamp will
ash as dened below.
High level alarms: the lamp quickly ashes red.
Meidum level alarms: the lamp slowly ashes yellow.
Low level physiological alarms: the lamp turns yellow without ashing.
Low level technical alarms: the lamp does not light.
3. Technical alarm lamp
This lamp will turn blue when a technical alarm occurs.
4. Display Screen
5. Power On/Off Switch
Press the switch to turn on the patient monitor. Press it again and hold
for 2 seconds to turn the patient monitor off. An indicator is built in this
switch. It turns on when the patient monitor is on and turns off when
the patient monitor is off.
6. AC power LED
It turns on when AC power is connected.
7. Battery LED
On: when the battery is being charged or already fully charged.
Off: when no battery is installed or no AC source is connected.
Flash: when the patient monitor operates on battery power.
8. press to silence all alarm sounds.
9. press to pause or restore alarms.
10. press to freeze or unfreeze waveforms.
11. press to start or stop recordings.
12. press to start or stop NIBP measurements.
13. If no menu is displayed on the screen, pressing it will enter the
main menu.
If there is a menu displayed on the screen, pressing it will close that
menu.
14. Knob







5 6 7
1
4
8 9 10 11 12 13
14
2
3

Mindray BeneView T5 Specifications

General

Brand	Mindray
Model	BeneView T5
Category	Heart Rate Monitor
Language	English