F3 Service Manual
Page 43
Table 4: Speaker Pod
3004-0017
Speaker Pod Kit F3 (includes all items in this
table) for F3/no LED display
3004-0037
F3L Speaker Pod Kit (includes all items in
this table) for F3L with LED display
1 0708-0005 Enclosure Speaker Lower
2 2701-0092 Decal Speaker/Handle, F3 only
3 30-29011-133 O-Ring Speaker
4 31-03512-580 Screw M3.5X12 Pozi2 Quantity 5
5 CMINE0390 Speaker 0.4W 8 Ohm
NOTE
The Speaker Pod has been upgraded, older versions of the Speaker Pod will only
have three screws (part 4 of Figure 27) and will not have the O-Ring.
a. To Remove the Speaker Pod:
Remove battery pack and sensitivity endcap from the detector.
Remove five (or three depending on pod version) screws (Part 4 of figure 39)
on underside of speaker pod.
Remove the top half of the speaker pod by lifting the pod gently upward until
the speaker pod plug comes clear of the handle.
Using fingers support the main wiring loom socket against the handle and
disconnect the speaker pod plug from the main wiring loom.
NOTE
Do not try and remove the ground balance/audio reset button or wiring from the
upper half of the speaker pod, these components are permanently sealed into the
upper half of the speaker pod.
Older F3 Speaker Pods only. Remove the screw (Figure 28) which secures the
lower half of the speaker pod to the handle. The nut for this screw sits in a
recess between the two handle halves. This screw is a unique screw and
cannot be used on any other part of the detector.
To Next Page
Loading...
Need help?
General
