Minelab F3 Service Manual

F3 Service Manual
Page 44
Figure 40: Old Speaker Pod.
 Remove the lower half of the speaker pod by lifting the rear of the pod upwards.
b. To Connect the Speaker Pod:
 When replacing or reassembling speaker pods it is important to note that an
F3L speaker pod is only functional on an F3L configured detector. Similarly,
the standard F3 speaker pod is only functional on the F3 detector. To
reassemble the speaker pod:
 Ensure that the handle has been fully assembled and the wiring loom is in place.
Refer to section 4.7.b. To Assemble the Handle.
 Peel back the shroud at the end of the speaker pod plug as shown in Figure 41.
Figure 41: Speaker Pod connector shroud.
 Attach the lower half of the speaker pod by inserting the tongue at the front top
of the handle into the recess in the lower half of the speaker pod. As shown in
figure

Minelab F3 Specifications

General

Brand	Minelab
Model	F3
Category	Metal Detector
Language	English