F3 Operations Manual
4
1.3 The F3 is a robust detector that is extremely simple to
operate. Its “switch and go” operation and ease of use combine to
keep operator training requirements to a minimum. There are no
complicated controls resulting in the operator being able to focus on
the vital task of mine detection. If mine detection occurs in a
“difficult” environment that includes highly mineralised ground or
electrical interference from over head power lines or other sources,
simple and quick semi-automatic procedures can be initiated by an
operator to allow the detector to continue performing at maximum
capability.
1.4 The F3 incorporates several safety features such as Low
Battery and Fault warnings, audible confirmation at the completion
of specific operational procedures, and continuous microprocessor
controlled internal self-testing. The inclusion of a Test Piece
provides an operator with a quick and easy test to ensure the
detector is working to its maximum capability.
1.5 Components of the F3 are manufactured within tightly
controlled parameters so that they can be interchanged in the field
without any requirement for calibration.
1.6 The F3 has been designed to satisfy MIL STD 810F:
Method 512.4 Water Immersion (IP67)
Method 514.5 Vibration
Method 516.5 Shock
NOTE
Although the F3 can withstand immersion to a depth of 3m for short
periods of time, it is NOT designed for use as an underwater
detector.
To Next Page
Loading...
Need help?
General
