3
CONTENTS
GETTING STARTED
This sections shows you how to quickly set up your detector to begin detecting with
minimal adjustment, and describes how to identify and adjust key detector functions.
1. Turn On
Factory default settings
The factory default settings are optimised for detecting in
almost all conditions, regardless of mineralisation and EMI
levels. The default settings are a practical choice for users
who want to begin successfully detecting without the need
to manually adjust the key detector settings.
Quick Start is best used with factory default settings:
`Sensitivity: Auto
`Ground Type: Difficult
`Noise Cancel: Automatic at startup
Factory Reset
Factory default settings can be restored at any time by
conducting a Factory Reset.
1. Ensure the detector is powered off.
2. Press and hold the power button for 7 seconds.
3. When reset is complete there is a confirmation tone,
and ‘FP’ (Factory Preset) appears on the display.
‘FP’ appears on the display
Quick Start
Beginning with Factory Default Settings is recommended for Quick-Start.
2. Wait for
Noise Cancel
3. Pump coil
(< 10 s)
4. Begin
Detecting
GPX 6000 automatically compensates
for ground noise, EMI, and sensitivity
within 20 seconds of turning on.
To Next Page
Loading...
Need help?
General
