EasyManuals Logo
Home>Mitsubishi>Automobile>COLT

Mitsubishi COLT User Manual

Mitsubishi COLT
273 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Indication lamps
E00501600012
Turn-signal indication lamps/
Hazard warning indication
lamps
E00501700286
These indication lamps blink in the fol-
lowing situations.
l
When the turn-signal lever is
moved to activate a turn-signal
lamp.
Refer to “Turn-signal lever” on page
3-23.
l
When the hazard warning flasher
switch is pressed to activate the
hazard warning lamps.
Refer to “Hazard warning flasher
switch” on page 3-23.
l
When the hazard warning lamps
automatically activate due to sud-
den braking while driving.
Refer to “Emergency stop signal sys-
tem” on page 4-26.
NOTE
l
If these indication lamps blink too
fast due to any operation other
than sudden braking, the cause
may be a blown lamp bulb or a faul-
ty turn-signal connection.
High-beam indication lamp
E00501800072
This indication lamp illuminates when
the high-beam is used.
Front fog lamp indication
lamp*
E00501900158
This indication lamp illuminates while
the front fog lamps are on.
Rear fog lamp indication lamp
E00502000084
This indication lamp illuminates while
the rear fog lamp is on.
Low coolant temperature indi-
cation lamp
E00502200028
When the engine coolant temperature is
low, this indication lamp illuminates and
then goes out when the temperature rises
to roughly 40 °C or more.
NOTE
l
When the indication lamp goes
out, this should be used as a rough
indication of when the heating
starts working.
l
If the indication lamp stays illumi-
nated, there may be a fault in the
temperature sensor or other com-
ponent. We recommend you to
have your vehicle inspected.
Warning lamps
E00502400017
Brake warning lamp
E00502502445
This lamp illuminates when the ignition
switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off
before driving.
With the ignition switch in the “ON” po-
sition, the brake warning lamp illumi-
nates under the following conditions:
l
When the parking brake lever has
been engaged.
With the ignition switch in the “ON” po-
sition, the brake warning lamp illumi-
nates and a buzzer sounds under the fol-
lowing conditions:
l
When the brake fluid level in the
reservoir falls to a low level.
l
The vehicle speed exceeds 8 km/h
(5 mph) with the parking brake ap-
plied.
l
When the brake force distribution
function is not operating correctly.
CAUTION
l
In the situations listed below,
brake performance may be com-
promised or the vehicle may be-
come unstable if brakes are ap-
plied suddenly; consequently,
avoid driving at high speeds or
applying the brakes suddenly.
Instruments and controls
3-17
3

Table of Contents

Other manuals for Mitsubishi COLT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi COLT and is the answer not in the manual?

Mitsubishi COLT Specifications

General IconGeneral
BrandMitsubishi
ModelCOLT
CategoryAutomobile
LanguageEnglish

Related product manuals