Coming home light
E00529000366
This function turns on the headlamps in the low-
beam setting for about 30 seconds after the ignition
switch is turned to the “OFF” position.
1. Turn the combination headlamps and dipper
switch to the “0” (OFF) or “AUTO” position
(for vehicles equipped with the automatic
lamp control).
2. Turn the ignition switch to the “OFF” posi-
tion and remove the ignition key.
3. Within 60 seconds of turning the ignition
switch to the “OFF” position, pull the turn-
signal lever towards you.
4. The headlamps will come on in the low
beam setting for about 30 seconds.
NOTE
l
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the turn-signal lever towards you.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” or
“ACC” position.
l
If the coming home light function is cancel-
led, the ignition switch must be turned to the
“ON” or “ACC” position before the function
can be operated again.
l
It is possible to modify functions as follows:
For details, we recommend you to consult a
MITSUBISHI MOTORS Authorized Service
Point.
• The time that the headlamps remain on
can be changed.
• The coming home light function can be
deactivated.
Headlamp levelling switch
E00506400695
The angle of the headlamp beam varies depending
upon the load carried by the vehicle.
The headlamp levelling switch (A) can be used to
adjust the headlamp illumination distance (when
the lower beam is illuminated) so that the head-
lamps’ glare does not distract the drivers of ap-
proaching vehicles.
Set the switch (referring to the following table) to
the appropriate position according to the number of
people and the load in the vehicle.
Except for vehicles with turbocharger
Vehicle
condi-
tion
Switch
position
“0” “2” “3” “3”
: 1 person
: Full luggage loading
Instruments and controls
3-22
3
To Next Page
Loading...
Need help?
General
