Connecting a VHF/UHF combined antenna
O If the antenna uses a 75-ohm coaxial lead, press the lead
directly onto the COAXIAL CABLE CO:NNECTOR on the TV.
O If the antenna uses twin leads, place the leads under the
screws on the adaptor. Tighten the screws with a screwdriver.
O Press the adaptor onto the COAXIAL C_BLE CONNECTOR on
the back of the TV.
O
75 ohm coaxial lead
0
twin leads
O
ANT/CABLI
Coaxial Cable Connector
Connecting separate VHF/UHF antennas
O Connect the leads from each antenna onto a combiner. (You can
purchase a combiner from your dealer or an electronics store.)
Press the combiner onto the COAXIAL CABLE CONNECTOR
on the back of the TV.
VHF Antenna UHF Antenna
Combiner
ANT/(_kBLE
75 g
Coaxial Cable Connector
The combiner you need may be different from the one shown in the
illustration, especially if your VHF antenna has a 75 ohm coaxial
lead.
6 Chapter Two: Connecting Your TV
To Next Page
Loading...
Need help?
General
