Mitsubishi LU2-4410 User Manual

PREPARATION FOR OPERATION
Connection of control box
The control box should be connected as shown to the right.
Note: (1) Be sure to turn tne power switch
off for safety before connecting
or disconnecting the connectors.
(2) The combination of the machine
heads with the motor control
panels are specified below. Use
special care for the correct
combination when replacing the
machine head or motor control
panel.
Machine head model
Control box model
LU2-4410-BIT
LU2-4430-B1T
XC-AM--20
•* means using voltage
12:110V~120V
24: 220V ~ 240V
Operation
box
Adjustment of needle bar stop position
1. Adjust of "UP" position
When the pedal is kicked down by heel, the
machine stops at "UP" position. If the marks
deviate larger than 3 mm, adjust as follows.
.—1. Disconnect the plug (12 pins) of cable from
the machine head.
—2. Run the machine and stop at "UP" position.
—3. While holding the pully, insert the "adjus
ting tool" in the hole®, then remove the
tool.
2. Adjust of "Down" position
When the pedal is "Neutral" the machine
stops at "Down" position. If the marks deviate
large than 5 mm, adjust as follows.
—1.
Disconnect the plug (12 pins) of cable from
the machine head.
—2. Run the machine and stop at "Down"
position.
—3. While holding the pully, insert the "adjus
ting tool" in the hole 0, then remove the
tool.
3. Confirm the stop oepration, then set the plug(12
pins) coming from the machine head into the
receptable.
-2 -
Round hole
in table
Timming mark Arm
Pully
white mark
"Up" position
Black mark
"Down" position
Adjusting
tool
AFTER
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com

Mitsubishi LU2-4410 Specifications

General

Brand	Mitsubishi
Model	LU2-4410
Category	Sewing Machine
Language	English