To connect a USB memory device
1. Park your vehicle in a safe place and turn
the ignition switch to the “OFF” position
or put the operation mode in OFF.
2. Open the glove compartment and remove
the connector cable A , B from clips C .
3. Connect a commercially available USB
connector cable D to the USB memory
device E .
4. Connect the commercially available
USB connector cable D to the vehicle’s
connector cable B . Be sure to hold the
terminal part A of the connector cable as
shown in the illustration.
5. Fix the connector cable A , B on the clips.
8
AUDIO SYSTEM
NOTE: Please refer to your Owner’s Manual for more detailed
information on how to use your audio system.
USB and iPod Input (if equipped)
Audio Remote
Control Button
(if equipped)
VOLUME
UP
VOLUME
Down
SEEK
Change
station or
track
MODE
Change the
audio source
C
D
B
A
To enter frequencies into the memory (AM/FM)
1. Press A to turn on the audio system.
2. Press B to select the desired band (AM/FM).
3. Press C to Seek Station
4. Hold down one of the Memory select buttons D (1-6) until it
beeps in order to save that station to memory.
To remove
1. Turn the ignition switch to the “OFF”
position or put the operation mode in OFF.
2. Remove the commercially available USB
connector cable D . Be sure to hold the
terminal part A of the connector cable as
shown in the illustration.
3. Fix the connector cable on the clips and
close the glove compartment.
To Next Page
Loading...
Need help?
General
