OFF
ON
CONT. RUN
AUTO
START/STOP
(1) Operation procedure
(a) For sub-engine drive
(Cabin controller)
(Cover assy, side R)
Setting the setting temperature/ room temperature
54
•
7
6
• Each time the [UP] switch is pressed, the setting temperature is raised by 0.5ºC.
• Each time the [DOWN] switch is pressed, the setting temperature is lowered by 0.5ºC.
Set the ELEC/DIESEL changeover switch on the concent assy in the “DIESEL” position.
Turn the main switch to “ON”.
Turn the CONT. RUN/AUTO changeover switch to one of the settings.
If the [UP] or [DOWN] switch is pressed continuously, the setting temperature will change continuously.
ADVICE
5 Operation
ADVICE
Set to the CONT.RUN switch only when loading refrigerated products. Do not load
frozen products.
Press the cabin controller’s [RUN/STOP] switch to turn the refrigeration unit “RUN”.
When the refrigeration unit is in the “RUN” state, the digital display changes to the setting
temperature/ room temperature display.
1Press the [UP] switch or the [DOWN] switch. The setting temperature display in the top row of the
digital display will blink. Pressing the switch again enables you to change the setting temperature.
2Set the setting temperature displayed in the top row of the digital display to the desired temperature,
then press the [SET] switch. The setting temperature will be finalized and the setting operation will end.
19
--
1
2
3
4
5
6
•
(Concent assy)
3 2
1
ADVICE
This cabin controller is equipped with a function that stores the setting temperature in
memory from the previous time the refrigeration unit was used (memory function). However,
to be sure, please check the setting temperature in the top row of the digital display.
To Next Page
Loading...
Need help?
General
