DAILY INSPECTION A-3
2.2 Work Inside the Machine
2.3 Machine Management
(1) The customer must take responsibility for managing the keys that are provided
with the machine (for the operation panel, control panel, peripheral devices, etc.).
(2) Keys that do not have to be used on a regular basis, such as the control panel key,
must be removed from the lock and stored elsewhere. If the machine is operated
with the key in the lock, people walking by could brush against the key, breaking it
or injuring themselves.
2.4 Oils Used
The customers themselves must receive an MSDS (safety data sheet for e.g. chemical
substances) for oils such as coolant (cutting fluid) and the various lubricants and
cooling oils, and the customer must take responsibility for securing and managing the
working environment, and for managing disposal of the oils. Take careful note of the
effects on the human body described in the MSDS.
WARNING
(1) Confirm that the main power supply to the machine is shut off before
entering the machine to do work inside it. Be aware that if you close
the machine door after entering the machine, it may not be possible to
open the door from the inside. If the machine model used is equipped
with a door lock prevention mechanism, take the door lock prevention
key inside the machine when doing the work. At the same time, fit a
padlock through the hole at the end of the lever of the door lock
mechanism, and take steps to ensure that the door lock mechanism is
not released by mistake. If the machine model used does not have a
door lock prevention mechanism, avoid entering the machine as far
as possible. If it is absolutely necessary to enter the machine,
implement measures to ensure that the door will not be closed before
starting the work.
(2) When entering the machine, make sure of your footing: take care that
you will not slip or stumble. Also select and wear appropriate safety
gear, such as a helmet, safety shoes, protective goggles, and so on,
as necessary, so as to ensure safety while working.
(3) If an operator is shut inside the machine, press the EMERGENCY
STOP button regardless of whether the power is ON or OFF, insert the
key into the external key hole in the door lock device fitted to the
machine cover, and turn the key to unlock the door and let the
operator out.
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
