mori seiki MSG-502 User Manual

DAILY INSPECTION A-9
6.2 Cleaning the Front Cover of the Tailstock (with Built-in Tailstock Spindle)
Dust and foreign matter will accumulate in the coolant holes on the front cover of the tailstock
allowing coolant to enter the bearings. This will cause the bearings to seize.
Clean the coolant holes in the front cover of the tailstock at least once a week.
<Cleaning interval>
Every 50 hours of operation
Do not use compressed air to remove dust and foreign matter from the coolant holes.
If compressed air is used, dust and foreign matter will enter the bearings.
6.3 Cleaning the Slideway Protection Covers
During dry cutting or when machining cast workpieces, carefully remove chips from the machine
so that they do not accumulate.
Be aware that any chip accumulation on moving parts, such as the slideway protection covers, will
interfere with proper operation and lead to mechanical problems.
6.4 Cleaning the Front Door Rail
If chips accumulate on the front door rail, the door will not open/close smoothly.
Clean the front rail regularly.
<Cleaning interval>
Every 50 hours of operation
<Procedure>
1) Turn off the power.
2) Remove the chips that have accumulated on the front door rail.
CAUTION

mori seiki MSG-502 Specifications

General

Brand	mori seiki
Model	MSG-502
Category	Lathe
Language	English