24 Base settings
5. Scroll
U
or d to the correct minute and press M to conrm.
NOTE
Once the alarm is set it will go o daily until it is set to o.
6.5 Contrast
You can change the contrast of your base display. There are 5 levels to choose from.
1. Press
M the display shows .
2. Scroll
d to and press M.
3. Scroll
U
or d to select the contrast you want and press M to conrm.
6.6 Dial mode
Your CL1I is set to tone dialling this is correct for India and should not be changed.
6.7 Flash time
Depending on your country and network operator, your phone has the flash time set as 300
ms. It is unlikely that you need to change this setting unless advised to do so. Your CL1I can
be set to 100/300/600/1000ms.
1. Press
M the display shows .
2. Scroll
d to
FLASh SEtUP
and press M.
3. Scroll
U
or d to select the flash time and press M.
6.8 PABX access code
If the CL1I is connected to a switchboard, you may need to enter a one-digit access code
in the dialling sequence to be able to connect to the outside line.
The access code will be displayed at the beginning of a number on the screen.
1. Press
M the display shows .
2. Scroll
d to and press M.
3. Scroll
U
or d to
O
n
/
OFF
.
4. If you select
O
n
using the keypad enter the access code and press M to conrm.
NOTE
If you want to change the access code just use the keypad to type the new code and it will
overwrite the old code.
6.9 Area code
You can set your local area code into the phone. When a number from that area code calls
only the local number will be displayed and stored. The area code can be up to 4 digits
long.
1. Press
M the display shows .
To Next Page
Loading...
Need help?
General
