Page 23 mrcool.com
No-Vac
®
Quick Connect
®
Line Set Installation
INSTRUCTIONS FOR USE WITH
NO-VAC™ QUICK CONNECT® LINE SET
SOLD SEPARATELY
:
1.
Take out matching male connectors M1 and M2.
2.
DC INVERTER and ensure the threads are clean and complete.
3.
the M1 connector to the
the M2 connector to the
4.
Repeat AIR HANDLER LINE SET.
Unroll and route the LINE SET AIR HANDLER and the DC INVERTER.
6.
LINE SET.
the LINE SET F1 M1 Connector 45N. the LINE SET F2
M2 Connector 45N.
8. Repeat AIR HANDLER LINE SET.
9.
At the the at the and open the
If close and that steps
3 and 7 Otherwise
close and that steps 3 and 7
the
and
to help .
50 N
50 N
70 N
70 N
M1
F1
M1 F1
M2
F2
M2 F2
*1
*1
*2
*2
3/8”
3/8”
3/4”
3/4”
Complete unit replacement
using the No-Vac® Quick Connect® lines
Air Handler
Open the stop valve
only after connecting
the refrigerate lines
A-coil Precharged
with 410 Refrigerate
Connect using precharged
line set with quick connect
ttings in length 15, 25, 35, 50 feet
MRCOOL Universal Series
DC Inverter
KINK RESISTANT, PRECHARGED, SIMPLE SECURE QUICK CONNECT, 100% CONNECTION GUARANTEE
ⱡFailure to follow the instrucons provided could result in severe harm to you, this product, or other property.
The manufacturer, distributor, and seller are not responsible for any harm resulng from the failure to follow
instrucons and the failure to follow these instrucons will void any and all warranes express or implied.
To Next Page
Loading...
Need help?
General
