3-6
MS-7005 Micro ATX Mainboard
Drive A/B
This item allows you to set the type of floppy drives installed. Available options:
[None], [360K, 5.25 in.], [1.2M, 5.25 in.], [720K, 3.5 in.], [1.44M, 3.5 in.], [2.88M, 3.5 in].
Floppy 3 Mode Support
The item allows you to set the Floppy 3 Mode. Available options are: [Disabled], [Drive
A], [Drive B], [Both].
Video
The setting controls the type of video adapter used for the primary monitor of the
system. Available options: [EGA/VGA], [CGA 40], [CGA 80], [MONO].
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Available options are:
[All Errors] The system stops when any error is detected.
[No Errors] The system doesn’t stop for any detected error.
[All, But Keyboard] The system doesn’t stop for a keyboard error.
[All, But Diskette] The system doesn’t stop for a disk error.
[All, But Disk/Key] The system doesn’t stop for either a disk or a key-
board error.
Base/Extended/Total Memory
The three items show the memory status of your system (read only).
To Next Page
Loading...
Need help?
General
