3-13
BIOS Setup
SiS USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) controller
and you have USB peripherals. Settings: [Enabled], [Disabled].
USB 2.0 Supports
This item is used to enable/disable the USB 2.0 Support. Settings: [Enabled],
[Disabled].
USB Keyboard/Mouse Support
Set to [Enabled] if you need to use a USB keyboard/mouse in the operating
system that does not support or does not have any USB driver installed, such
as DOS and SCO Unix.
SiS AC97 Audio
[Auto] allows the mainboard to detect whether an audio device is used. If an
audio device is detected, the onboard AC97 (Audio Codec’97) controller will be
enabled; if not, it is disabled. Disable the controller if you want to use other
controller cards to connect an audio device. Settings: [Auto], [Disabled].
SiS 10/100M Ethernet
This item is used to enable/disable the 10/100M Ethernet function. Settings:
[Enabled], [Disabled].
Onboard Lan Boot ROM
This item is used to decide whether to invoke the Boot ROM of the Onboard LAN
Chip. Settings: [Enabled], [Disabled].
Onboard SuperIO Device
Press <Enter> and the following sub-menu appears:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system
has no floppy drive, select [Disabled] in this field. Setting options: [Enabled
[Disabled].
To Next Page
Loading...
Need help?
General
