CHAPTER 3
AMI
®
BIOS USERS GUIDE
3-15
Restore on AC/Power Loss
The settings are power on, power off or last state. During power
on, after every AC power loss, the system will be turned on. During last
status, after every AC power off, whatever the system status, it will be the
same when the AC power returns. During power off, after every AC power
loss, the system will remain shut down.
Resume On Ring/LAN
During Disabled, the system will ignore any incoming call from the
modem/LAN network card. During Enabled, the system will boot up if
there’s an incoming call from the modem/LAN network card.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
Resume On PME#
During Disabled, the system will ignore any event on PME (Power
Management Event). During Enabled, the system wull boot up if there’s an
event on PME. The default setting is Disabled.
Resume On RTC Alarm
This function is for setting the Date, Hour, Minute, and Second for
your computer to boot up. During Disabled, you cannot use this function.
During Enabled, Choose the Date, Hour, Minute, and Second:
RTC Alarm Date Choose which day the system will boot up.
RTC Alarm Hour Choose which hour the system will boot up.
RTC Alarm Minute Choose which minute the system will boot up.
RTC Alarm Second Choose which second the system will boot up.
Note: If you have change the setting, you must let the system boot up until
it goes to the operating system. Then, power off the system. This
function will work the next time you power on.
To Next Page
Loading...
Need help?
General
