3-20
MS-7222 Micro-ATX Mainboard
PNP/PCI Configurations
This section describes configuring the PCI bus system and PnP (Plug & Play) feature.
PCI, or Peripheral Component Interconnect, is a system which allows I/O devices to
operate at speeds nearing the speed the CPU itself uses when communicating with
its special components. This section covers some very technical items and it is
strongly recommended that only experienced users should make any changes to the
default settings.
Primary Graphic’s Adapter
This setting specifies which VGA card is your primary graphics adapter. Setting
options are:
[AGP] The system initializes the installed AGP card first. If an AGP card is
not available, it will initialize the PCI VGA or Internal VGA card.
[PCI] The system initializes the installed PCI VGA card first. If a PCI VGA
card is not available, it will initialize the AGP or Internal VGA card.
[Internal] The system initializes the installed Internal VGA card first. If a Internal
VGA card is not available, it will initialize the AGP or PCI VGA card.
PCI Latency Timer
This item controls how long each PCI device can hold the bus before another takes
over. When set to higher values, every PCI device can conduct transactions for a
longer time and thus improve the effective PCI bandwidth. For better PCI performance,
you should set the item to higher values. Setting options: [0]~ [255].
To Next Page
Loading...
Need help?
General
