Chapter 3
3-16BIOS Setup
User Password
Sets User Password for system security. Enters the user password if set; but user
might have limited rights to change the BIOS items.
Important
When selecting the Administrator / User Password items, a password box will appear
on the screen. Type the password then press <Enter>. The password typed now will
replace any previous set password from CMOS memory. You will be prompted to
conrm the password. You may also press <Esc> to abort the selection.
To clear a set password, press <Enter> when you are prompted to enter a new
password. A message will conrm the password is being disabled. Once the password
is disabled, you can enter the setup and OS without authorization.
Make U-Key at
Makes a key at the USB ash drive to prevent other people from accessing the
system. Only the user who has the key with the ash drive can access the system.
Chassis Intrusion Conguration
Press <Enter> to enter the sub-menu.
Chassis Intrusion [Disabled]
This function will be available if the chassis equips a chassis intrusion switch.
Once the chassis is opened, the system will record and issue a warning message.
To clear the warning message, set the item to [Reset], then it will return to
[Enabled] later. [Options: Disabled, Enabled, Reset]
Save & Exit
Discard Changes and Exit
Exit BIOS setup without saving any change. This it is used to abandon all changes
and exit BIOS setup.
Save Changes and Reboot
This item is used to save all changes and reboot the system.
Save Changes
This item is used to save current changes.
Discard Changes
This item is used to discard current all changes and restore to the previous values.
Restore Defaults
This item is used to restore/ load all default values by the BIOS vendor.
Boot Override
The installed boot-able devices will appear on this menu, you can select one of them
be a boot device to start booting.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
To Next Page
Loading...
Need help?
General
