Buckle Lock Operation
Heating the water
Place the cover over the spa. Refer to “Controller operation” to turn on the heater.
10
Lock Unlock
CONTROLLER OPERATION
Heater Button
LED Display
Bubble Button
Up Button
Filter Button
Timer Button
Down Button
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
NOTE: Inflate the spa tub first before installing the filter cartridge.
NOTE: Always use a filter cartridge when the spa is in use and filled with water.
WARNING: Do not overfill the spa.
Do not operate the spa until the water reaches the MIN mark.
Never move the spa tub with water inside.
Never pour water with a temperature higher than 40 °C (104°F) into the spa directly. We recommend that you fill the spa tub with lukewarm water to heat it
more quickly and save energy. Using tap water for spa filling to minimize the influence of unwanted content, such as minerals.
Installing the Filter Cartridge
1. Attach the filter cartridge base to the spa tub inlet grid (upper position) and turn it slightly to secure. NOTE: The filter cartridge base is designed to be
screwed on and off. Never exert force as this could cause damage.
2. Attach the filter cartridge to the base.
Filling the spa with water
1. Before filling with water ensure the bottom drain valve cap is securely closed.
2. Fill the spa tub with fresh water to a level between MIN and MAX marked on the inside of the spa wall.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when not in use.
Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g. 10ml/l of free Chlorine).
®
®
To Next Page
Loading...
Need help?
General
