DRAINAGE, CLEANING AND STORAGE
Spa Drainage
2
1
Lift up the spa when there is only a little water left.
Press the BUBBLE button to dry the spa pool.
Turn off all the functions
4
5
6
13
Spa Tub Cleaning
After the spa water is drained, use a sponge and a mild soap solution to wipe away any soil or stains on the inside of the spa wall. Rinse
thoroughly before refilling with clean water.
IMPORTANT: Do not use steel wool, hard brushes or abrasive cleaners.
Spa Tub and Air Bladder (*Optional) Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
●
●
●
●
●
●
●
15
minutes
UP DOWN
BUBBLE
TIMER
1 32
pin holepin hole
Water Treatment:
It is good practice with an existing spa to keep all air jets open and valves closed to allow chemically treated water to flush through all pipework.
Always follow the chemical manufacturer’s directions, and the health and hazard warning.
Bromine are highly recommended for TEKAPO / BERGEN.
Never mix chemicals together. Add the chemicals to the spa water separately. Thoroughly dissolve each chemical before adding it to the water.
Please note that chlorine and bromine products should never be mixed. This is extremely dangerous. If you usually use chlorine-based products and
you want to switch to bromine-based products, or vice versa, it is essential that you change the spa water first.
Do not add chemicals if the spa is occupied. This can cause skin or eye irritation.
Do not overuse chemicals or use concentrated chlorine. This can damage the spa tub and cause potential hazard to your skin. Improper chemical use
will void the warranty.
3
Spa deflation
1. Unscrew the valve completely to deflate the spa.
2. Once deflation is completed, replace the cap.
To Next Page
Loading...
Need help?
General
