NOTE: Your spa will require additional air to be added from time to time. Changes in temperature from day to night will change the pressure in the spa and
may cause a certain amount of deflation.
9
SPA SET-UP
2. 3.
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
BUBBLE
Yellow
ON
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
OFF
Unboxing
Take out the ground mat and spread it over the cleared area. Then spread out the spa tub over the
ground cloth and point the drain valve towards a suitable draining area.
NOTE: Spread the ground cloth with the bubbles facing down over the cleared area where you
intend to set up your spa.
Heater Resetting:
Please reset the heater when the product is used for the first time or after a long period of storage.
Operation: Find the yellow ring as shown in the picture. Pull it down gently and then release it.
NOTE: The heater cannot work or be reset when the water temperature or ambient temperature is
higher than 40°C (104°F).
Inside
control box
NOTE: Move the entire package to the selected site. Do not drag the spa tub across the ground as this can cause damage and leakage. Open the carton
carefully as this can be used to store the spa over long periods or when not in use.
NOTE:
Lay out all the parts on the ground and make sure they are all accounted for. For missing or damaged parts contact the appropriate MSpa
after-sales service center.
ASSEMBLY
Inflating the spa tub wall
1. Plug the spa into the grounded supply socket. Press RESET button on the PRCD, the screen on controller shows numbers.
2. Turn the inflation knob to the inflation status <ON> and long press (≥2 minutes) the bubble button on the controller to start inflating until the yellow
section of the manometer is pushed out.
3. Stop pressing the bubble button and turn the knob back to <OFF> for activating other functions. .
Ensure the manometer points to the Yellow section in the following conditions
After inflation, before filling the water.
When leaving the spa outdoors unattended for long periods of time at a temperature higher than 20°C (68°F).
Ensure the manometer points to the Green section in the following conditions
When the spa is filled with water.
When the spa is in use.
WARNING: If the manometer points to the White section, the air pressure of your spa is too high.
Slightly rotate the valve cap counter-clockwise to release some air. Then tighten the cap after the pointer returns to the
Green or Yellow section.
IMPORTANT: ALWAYS READ THE MANOMETER TO ENSURE THAT THE SPA IS FILLED AT THE CORRECT AIR PRES-
SURE FOR THE CONDITIONS.
YELLOW
YELLOW
GREEN
YELLOW
GREEN
WHITE
●
●
●
●
To Next Page
Loading...
Need help?
General
