5
Always add chemicals to water, never add water to chemicals. Adding water to chemicals may cause strong
fumes or violent reactions and hazardous chemical spray.
For water that has already been used, dispose of it promptly or use water chemicals for cleaning.
Usually, it is recommended to drain and refill a spa with clean water every 3-5 days.
Use the chemical kit for disinfection in accordance with manufacturer’s instructions.
Do not leave or set up the spa with a temperature lower than 4°C (39°F) if the heater is not operating.
Always enter and exit the spa or hot tub slowly and cautiously. Take extra care if the floor is wet.
To avoid damage to the pump, never turn on the spa or hot tub if it is not filled to the minimum water line.
The spa or hot tub must only be placed on a properly prepared site that meets the floor loading requirement.
Do not leave the spa empty for an extended period of time. Drain the spa completely if it is not going to be used
for a long period of time. Do not expose the spa to direct sunlight. Check regularly before each use. When the spa
is not in use, store it away immediately or keep it in an enclosed area.
Open the spa top lid when the Bubble function is on.
In order to avoid a hazard due to the inadvertent resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched
on and off by the utility.
Once the spa is installed, refer to the relevant chapters for details concerning cleaning, periodic checks and other
maintenance.
Do not add bath oil or bath salt to the spa water.
NEVER PUT HEAD UNDER WATER.
Avoid swallowing the spa water.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
! CAUTION
To Next Page
General
