MTD 148-802-000 User Manual

I
PARKING BRAKE
To set the parking brake, depress the clutch-brake
pedal and pull up the parking brake knob. It will stay
in the raised position. To release the parking brake,
depress and release the clutch-brake pedal. See figure
11 .
INCLINE ASSISTANCE BRAKE LEVER
When stopping on a hill, hold the incline assistance
brake lever back while you release the clutch-brake
pedal until the tractor begins to move, then releas 3 the
lever. This lever permits smoother starts and c utch
engagement by holding the tractor during the brake
release/clutch engagement operation. See figure; 11.
LIFT LEVER
The five position lift lever is used to change the
operating position of the attachments. To operate, pull
the lever towards you. To release, move the lever to
the right and then forward. See figure 11.
POWER TAKE-OFF (PTO) LEVER
The PTO lever is located on the right side 0 the
dashboard. To engage the PTO, lift the lever slowly and
lock it into the notch. See figure 10.
■ ^NOTE
The PTO lever must be in the
disengaged position (down) when
starting the engine when shifting into
reverse and if the operator leaves the
seat.
OPERATION
CAUTION
READ OPERATOR'S IVIANUAL(S) • NEVER CARRY CHILDf{EN
KNOW LOCATION AND FUNCTION OF ALL CONTROLS
KEEP SAFETY DEVICES (GUARDS, SHIELDS AND SWITCljES)
PLACE AND WORKING
REMOVE OBJECTS THAT COULD BE THROWN BY BLADES)
DO NOT OPERATE THE UNIT WHEN CHILDREN AND OTHERS
ARE AROUND,
ALWAYS LOOK BEHIND THE UNIT BEFORE BACKING UP
DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR
IF THE UNIT STOPS GOING UPHILL, STOP BLADE(S) AND B
SLOWLY DOWNHILL
BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE Pl|AC-
ING HANDS OR FEET NEAR BLADE(S)
BEFORE LEAVING OPERATOR'S POSITION, SHUT ENGINE|0FF
AND REMOVE KEY
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instri cted
in the separate engine manual packed with your trac¬
tor. Read instructions carefully.
■ i^NOTE
Your tractor is shipped without oil;
however, a small amount of oil may be
present from the factory. Do not overfill.
A t WARNING i
Never fill fuel tank indoors, with en¬
gine running or while engine is hot.
OPERATING THE TRACTOR
■ ^NOTE
This unit is equipped with a safety
interlock system for your pro¬
tection. The purpose of the safety
interlock system is to prevent the
engine from cranking or starting
unless the clutch-brake pedal is
depressed and the PTO lever is
in the disengaged position. In addi¬
tion, the PTO lever must be in the
disengaged position when the unit
is put into reverse or the engine
will shut off. If the operator leaves
the seat with the PTO lever engaged, the
engine wili shut off.
A t WARNING t
Do not operate the tractor if the in¬
terlock system Is malfunctioning be¬
cause it is a safety device, designed
for protection.
1. P lace the PTO lever In the disengaged (down)
position.
2. P ull out the choke control. A warm engine requires
less choking.
3. S et the throttle control in the FAST position.
4. D epress the clutch-brake pedal and hold it down.
5. T urn the ignition key to the START position. After
the engine starts, release the key.
6. S lowly push in the choke as the engine warms up.
7. W ith the clutch-brake pedal depressed, move the
gear shift lever into one of the forward gears or
reverse.
8. S iowly release the clutch-brake pedal and the trac¬
tor will move forward.
9. W hen stopping, depress the clutch-brake pedal.
This will apply both the clutch and the brake.
12

MTD 148-802-000 Specifications

General

Brand	MTD
Model	148-802-000
Category	Tractor
Language	English