Multiplex 116 User Manual

Section 2 Installation
Part Number 020002777 10/11 2-11
REQUIREMENTS
• Conduit can be run through floor or ceiling chase.
• 60°F (15.6°C) minimum and 105°F (40.5°C)
maximum operating ambient conditions.
• For indoor installation only.
• Syrup supply can be located on stand or adjacent to
refrigeration unit.
Installer Instructions
These equipment instructions are intended to assist
qualified personnel in the unpacking, locating and the
initial operation of the Multiplex Beverage Equipment
and/or Post Mix Refrigeration Unit.
PREPARATION
The Multiplex Beverage Equipment Soda Tower is pre-
assembled in the factory and requires minimum
installation.
For future reference or to be used when ordering parts,
record the Model Number, Serial Number, Part Numbers
of Unit, Condenser (if remote), Towers, etc., and Date of
Installation on the inside of this Manual. Leave manual
on site in a safe place. Do not discard manual.
Ambient Location Requirement
This equipment is rated for indoor use only. It will not
operate in sub-freezing temperature. In a situation when
temperatures drop below freezing, the equipment must
be turned off immediately and properly winterized.
Contact the manufacturer for winterization process.
Electrical
GENERAL
MINIMUM CIRCUIT AMPACITY
The minimum circuit ampacity is used to help select the
wire size of the electrical supply. (Minimum circuit
ampacity is not the beverage/ice machine’s running amp
load.) The wire size (or gauge) is also dependent upon
location, materials used, length of run, etc., so it must be
determined by a qualified electrician.
ELECTRICAL REQUIREMENTS
Refer to Machine Model/Serial Plate for
voltage/amperage specifications.
ELECTRICAL SPECIFICATIONS
MAKING THE ELECTRICAL CONNECTIONS
1. Locate the low voltage transformer and position it
below the tower in a shielded and protected area. Use
the screws provided to secure the transformer to the
cabinet.
2. Route the transformer cords up to the rear of the
dispensing tower and plug into the cords in the rear of
the tower.
3. Connect the transformer power supply cord to an
appropriate wall outlet. Do Not turn "on" the power
switch at this time.
Important
The remainder of these instructions is to be
completed by an authorized Multiplex Installer.
Important
This publication must be saved for future reference.
Read instructions before attempting installation.
! Warning
All wiring must conform to local, state and national
codes.
ALL TOWERS
120 or 220VAC primary
24 VAC secondary
50/60Hz

Multiplex 116 Specifications

General

Brand	Multiplex
Model	116
Category	Dispenser
Language	English