National Instruments MXI User Manual

Appendix B EEPROM Configuration
© National Instruments Corporation B-3 PCI-MXI-2 for Linux
4. Replace the computer cover.
5. Turn on the computer. The computer should boot this time because the
factory-default configuration is being used to initialize the PCI-MXI-2
module.
6. Run
vxiedit to re-adjust the PCI-MXI-2 configuration. Refer to
Chapter 6, NI-VXI Configuration Utility, for instructions on using this
utility.
7. After saving the configuration, reboot the computer.
8. Remove the top cover or access port to the PCI bus.
9. Change switch 1 (FOV) on U17 (SW1 on the PCI-MXI-2 Universal)
to the OFF position.
10. Replace the computer cover.
11. Turn on the computer. If the computer does not boot with this
configuration, you will have to repeat these steps, modifying your
configuration until a final configuration is reached.

National Instruments MXI Specifications

General

Brand	National Instruments
Model	MXI
Category	Recording Equipment
Language	English