■
Setup Prompt Timeout—This setting specifies the number of seconds
the system waits for a BIOS Setup menu keypress (the <Delete> key). The
default value is 2.
■
Bootup NumLock State—This setting specifies the power-on state of the
keyboard NumLock setting. The default value is On.
Security Menu
Use this menu to enable BIOS security options.
■
Administrator Password—This setting specifies a password that must be
entered to access the BIOS Setup Utility. If only the Administrator’s password
is set, this setting limits access to only the BIOS setup program and is asked
for only when entering the BIOS setup program. By default, no password is
specified.
■
User Password—This setting specifies a password that must be entered to
access the BIOS Setup Utility or boot the system. If only the user’s password
is set, this is a power on password and must be entered to boot or enter the
BIOS setup program. In the BIOS setup program, the user has Administrator
rights. By default, no password is specified.
■
Secure Boot—Use this menu to enable or disable secure boot. If factory
keys are not installed, install the factory keys from the Secure Boot submenu
before turning on secure boot. There are two profiles for secure boot:
standard or custom. Standard installs the default keys from the system, while
custom allows you to freely install user-defined keys.
Save & Exit Menu
The Save & Exit setup menu includes all available options for exiting, saving, and
loading the BIOS default configuration. As an alternative to this screen, press <F9>
to load optimal BIOS default settings and <F10> to save changes and exit setup.
The Save & Exit setup menu includes the following settings:
© National Instruments
23
PXIe-8822/42/62 Getting Started
To Next Page
Loading...
Need help?
General
