Native Instruments AUDIO 8 DJ User Manual

AUDIO 8 DJ – 6
2.2 Caution
Before connecting the AUDIO 8 DJ hardware to other electronic components,
turn off the power for all devices. Before powering your system up or down, set
all volume levels to minimum. Gradually raise the volume controls while playing
your instruments to set the desired listening level.
Do not place the AUDIO 8 DJ hardware in an unstable position where it might
accidentally fall to the ground.
Before moving the AUDIO 8 DJ hardware, remove all connected cables.
Never subject the unit to extreme temperatures (e.g. direct sunlight in an en-
closed vehicle or near a heat source), or high levels of vibration.
Do not use excessive force on the buttons, knobs, switches or connectors.
When cleaning the AUDIO 8 DJ hardware, use a soft, dry cloth. Do not use
paint thinner, solvents, cleaning uids, or chemically-impregnated wiping
cloths.
2.3 Important Notes
Disclaimer: NATIVE INSTRUMENTS GmbH cannot be held responsible for
damage or data loss caused by improper use of, or modication to, the AUDIO
8 DJ hardware or software. It is your responsibility to back up data you do not
want to lose.
Specications subject to change: The information contained in this manual is
believed to be correct at the time of printing. However, NATIVE INSTRUMENTS
reserves the right to make changes to the specications of software and hard-
ware at any time without notice or obligation to update existing units.
Nameplate location: The nameplate is located on the bottom of the AUDIO 8
DJ hardware. It lists the products’ model name and the serial number.
►
►
►
►
►
►
►
►
►

Native Instruments AUDIO 8 DJ Specifications

General

Brand	Native Instruments
Model	AUDIO 8 DJ
Category	Recording Equipment
Language	English