To Next Page

To Previous Page

CONSOLE SETUP MODE

The Console Setup Mode lets you input the date and time, set the units of measurement to either English or Metric,

FRQWUROWKHVRXQGVHWWLQJVRQRႇRUVHHPDLQWHQDQFHVWDWLVWLFV(UURU/RJDQG5XQ+RXUV±IRUVHUYLFHWHFKQLFLDQXVH

only).

1. To go into the Console Setup Mode:

- For the later version of the E618 and all E628, hold down the PAUSE/END button and Increase(c) button together

for 3 seconds while in the Power-Up Mode.

- For the earlier version of the E618, hold down the PAUSE/END button and Left(e) button together for 3 seconds

while in the Power-Up Mode.

Note:3XVK3$86((1'WRH[LWWKH&RQVROH6HWXS0RGHDQGUHWXUQWRWKH3RZHU8S0RGHVFUHHQ

2. The Console display shows the Date prompt with the current setting. To change, push the Increase/Decrease buttons

WRDGMXVWWKHFXUUHQWO\DFWLYHYDOXHÀDVKLQJ3XVKWKH/HIW5LJKWEXWWRQVWRFKDQJHZKLFKVHJPHQWLVWKHFXUUHQWO\

active value (month / day / year).

3. Push OK to set.

4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust

WKHFXUUHQWO\DFWLYHYDOXHÀDVKLQJ3XVKWKH/HIW5LJKWEXWWRQVWRFKDQJHZKLFKVHJPHQWLVWKHFXUUHQWO\DFWLYHYDOXH

(hour / minute / AM or PM).

5. Push OK to set.

6. The Console display shows the Units prompt with the current setting. To change, push OK to start the Units option.

Push the Increase/Decrease buttons to change between “MILES” (Imperial English units) and “KM” (metric units).

Note: If the units change when there is data in User Statistics, the statistics convert to the new units.

 3XVK2.WRVHW

8. The Console display shows the Sound Settings prompt with the current setting. Push the Increase/Decrease buttons

to change between “ON” and “OFF”.

9. Push OK to set.

10. The Console display shows the TOTAL RUN HOURS for the machine.

If resetting the Console:

A. Push and hold down the PAUSE/END and Left(e) buttons for 5 seconds. The Console will display the current

Firmware Version.

B. Push the Increase(cEXWWRQXQWLOWKH5(6(7&2162/(RSWLRQLVGLVSOD\HG3XVKWKH2.EXWWRQDQGFRQ¿UP

the Console Reset.

 )RUWKHQH[WSURPSWSXVKWKH2.EXWWRQ

12. The Console display shows the Software Version prompt.

 )RUWKHQH[WSURPSWSXVKWKH2.EXWWRQ

14. The Console will display the Power-Up Mode screen.

few seconds, and then on. The Console will display STUDIO MODE when successfully shifted into Studio mode.

Note: Do not switch your machine into Studio mode unless the machine is in a non-home environment. The Console

must be reset to switch back into the Home mode. If the Console is reset, the Console setup, user records and

workout records will be reset to defaults.

Nautilus E618 User Manual

Other manuals for Nautilus E618