To Next Page

To Previous Page

Quick Start

Figure A.1

15-pin mini D-SUB

Captive Signal Cable

To attach the MultiSync

monitor to your system, follow these in-

structions:

1. Turn off the power to your computer.

2. If necessary, install the display card into your system. For more information,

refer to the display card manual.

3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the

connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync Macintosh cable adapter (not included) to

the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini

D-SUB end of the captive signal cable to the MultiSync Macintosh cable

adapter on the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync Macintosh cable adapter, call

NEC Technologies at (800) 820-1230.

4. For download information on the Windows

95/98 INF file for your

MultiSync monitor, refer to the References section of this User’s Manual.

5. Connect one end of the power cord to the MultiSync monitor and the other

end to the power outlet (Figure C.1).

6. Turn on the monitor (Figure D.1) and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of

this User’s Manual.

15500251.wpc 5/7/99, 12:54 PM5

NEC 90 User Manual

Questions and Answers: